INTRODUCTION
General maintenance safety
Keep area used for servicing the machine clean and dry. Clean up spilled fluids.
Service machine on a firm level surface.
Install guards and shields after servicing the machine.
Close all access doors and install all panels after servicing the machine.
Do not attempt to clean, lubricate, clear obstructions or make adjustments to the machine while it is in motion or while
the engine is running.
Always make sure working area is clear of tools, parts, other persons and pets before you start operating the machine.
Unsupported hydraulic cylinders can lose pressure and drop the equipment causing a crushing hazard. Do not leave
equipment in a raised position while parked or during service, unless securely supported.
Jack or lift the machine only at jack or lift points indicated in this manual.
Incorrect towing procedures can cause accidents. When towing a disabled machine follow the procedure in this man-
ual. Use only rigid tow bars.
Stop the engine, remove key and relieve pressure before disconnecting or connecting fluid lines.
Stop the engine and remove key before disconnecting or connecting electrical connections.
Scalding can result from incorrect removal of coolant caps. Cooling system operates under pressure. Hot coolant
can spray out if a cap is removed while the system is hot. Allow system to cool before removing cap. When removing
a cap turn it slowly to allow pressure to escape before completely removing the cap.
Replace damaged or worn tubes, hoses, electrical wiring, etc.
Engine, transmission, exhaust components, and hydraulic lines may become hot during operation. Take care when
servicing such components. Allow surfaces to cool before handling or disconnecting hot components. Wear protective
equipment when appropriate.
When welding, follow the instructions in the manual. Always disconnect the battery before welding on the machine.
Always wash your hands after handling battery components.
Wheels and tires
Make sure tires are correctly inflated. Do not exceed recommended load or pressure. Follow instructions in the
manual for proper tire inflation.
Tires are heavy. Handling tires without proper equipment could cause death or serious injury.
Never weld on a wheel with a tire installed. Always remove tire completely from wheel prior to welding.
Always have a qualified tire technician service the tires and wheels. If a tire has lost all pressure, take the tire and
wheel to a tire shop or your dealer for service. Explosive separation of the tire can cause serious injury.
DO NOT weld on a wheel or rim until the tire is completely removed. Inflated tires can generate a gas mixture with
the air that can be ignited by high temperatures from welding procedures performed on the wheel or rim. Removing
the air or loosening the tire on the rim (breaking the bead) will NOT eliminate the hazard. This condition can exist
whether tires are inflated or deflated. The tire MUST be completely removed from the wheel or rim prior to welding
the wheel or rim.
47681318 16/05/2017
15
