Maintenance
32
11. Install side panels by sliding tabs into steering
tower and inserting pin into flange of footrest.
Secure with screws and wing nuts (Fig. 38).
1
2
3
4
5
1260
4
Figure 38
1.
Battery
2.
Side panel tabs
3.
Screw
4.
Wing nut
5.
Pin
12. Install power lift pump.
Checking Electrolyte Level
1.
With the engine off, open the hood. To see the
battery the power lift pump must first be moved
(Fig. 39). Loosen wing nut and move pump to
the side for battery access (Fig. 39).
2350
1
2
3
Figure 39
1.
Power lift pump
2.
Wing nut
3.
Battery
2.
Open covers to see into the cells. The electrolyte
must be up to the lower part of the tube
(Fig. 40). Do not allow the electrolyte to get
below the plates. (Fig. 40).
3.
If the electrolyte is low, add the required amount
of distilled water; refer to Adding Water to the
Battery, page 32.
1
2
3
1262
Figure 40
1.
Filler caps
2.
Lower part of tube
3.
Plates
Adding Water to the Battery
The best time to add distilled water to the battery is
just before you operate the machine. This lets the
water mix thoroughly with the electrolyte solution.
1.
Clean the top of the battery with a paper towel.
2.
Lift off the filler caps (Fig. 40).
3.
Slowly pour distilled water into each battery cell
until the level is up to the lower part of the tube
(Fig. 40).
IMPORTANT: Do not overfill the battery
because electrolyte (sulfuric acid) can cause
severe corrosion and damage to the chassis.
4.
Press the filler caps onto the battery.
5.
Install power lift pump and tighten wing nut
(Fig. 39).
6.
Press the filler caps onto the battery.
