- 18 -
▲
MENU
3-4-4. Operating Procedure in Each Mode
Functions of each button are listed below.
•
Select: Press the [ AIR ADJ.] button for 1 second.
(The item will switch sequentially each time
pressing the button)
•
Choose: Press both [ AIR ADJ.] and [ POWER]
buttons at the same time.
•
Return: Press the [ POWER] button.
(Each time pressing the button, it will go back
to the previous section.)
•
Reverse the Selection List: Press and hold both [ AIR ADJ.] and [ POWER]
buttons at the same time for 3 seconds.
(A) Alarm Test
Shift to the user mode (page 16), and follow the following steps.
1) When [AL TEST] is displayed, press both [ AIR
ADJ.] and [ POWER] buttons at the same time.
--> [AL1] (1
st
alarm) will be indicated (selected).
2) To select [AL2] (2
nd
alarm), press the [ AIR ADJ.]
button.
--> [AL2] (2
nd
alarm) will be displayed (selected).
3) Press both [ AIR ADJ.] and [ POWER]
buttons at the same time.
--> Selected alarm test will be performed and
current alarm volume level will be indicated.
MENU
MENU
MENU
<1
st
stage alarm>
MENU
<2
nd
stage alarm>
MENU
(2
nd
stage alarm)
(1
st
stage alarm)
▲
▲
▲
How to reverse the display order of selection list
Press and hold both [ AIR ADJ.] and [ POWER]
buttons at the same time to reverse the display order of
selection list. After a beep sound, an arrow sign in the bottom
right corner of the LCD will flip vertical.
The same operation can reverse the display order again.
The display order will return to the default ( up arrow) when
the power is turned OFF.
NOTE
MENU
(Flipped
down arrow)
▲
▲
▲
▲
- 17 -
* Long-life mode is configured “ON” from the shipping. When the long-life mode is switched to
“OFF”, the detection cycle of combustible gas sensor will be short, response time will be fast,
and battery life will be half of the long-life mode.
* XA-4000IIL Datalogger Kit is necessary to read logging data. Read the instruction manual of
XA-4000IIL Datalogger Kit on how to read the logging data.
3-4-3. Quit the User Mode
In the user mode, whenever pressing the [ POWER] button will go back to the
previous section.
To quit user mode, keep pressing the [ POWER] button until it returns to the <Gas
Concentration Display>.
Mode
Functions and Setting
Reference
Alarm Test
[AL TEST]
Operation test of alarm lamps on 1
st
sand 2
nd
alarms,
buzzer, and vibration.
Also, the buzzer volume can be changed on gas alarm.
Page 18
Buzzer ON/OFF
Buzzer ON/OFF during the alarm and
button operation
Page 20
Buzzer Volume
Buzzer volume setting during the alarm
and button operation
Page 21
Clock Adjustment
Setting of time and date
Page 22
Each Setting
[SET UP]
Long-life Mode*
Battery life mode by switching the
detection cycle of combustible gas
sensor.
Page 23
Logging
[LOG]
Log detection data (time, gas concentration and temperature)
at a preset cycle.
The following operation can be performed in this mode:
•
Start and stop logging
•
Delete logging data
•
Set logging cycle
•
Read the logging data
Page 24
to 26
MENU
MENU
(Returns to Gas Concentration Display from Alarm Test AL1)
MENU
MENU
MENU
<Gas Concentration Display>