7
speakers
Carries the Main Speaker Outputs, Alt 1 and Monitor
Mix Output signals. In an ideal world, the Main Speaker
Outputs and Monitor Mix Outputs will be connected to the
main studio speakers. Alt 1 would be connected to your
secondary studio monitors.
aux sends
All 7 auxiliary sends (1, 2, 3, A[stereo] and B[stereo])
appear here. Connect these to your patch bay, XLRs, or
outboard effects inputs.
sls, red light, TB, listen
The first two channels carry the Studio Loud Speaker
(SLS) output signals. The external input to the SLS
are available on channels three and four. The Studio
Red Light is to be connected to channel 5, taking into
consideration that this circuit is not suitable for mains
power and should be run at 1 AMP 24 Volts maximum.
Connect an External Talkback Switch, if desired, to
channel 6. A Listen Mic Input can be connected to
channel 7, and PFL Out is available on channel 8.
Headphones
Carries two balanced (channels one through four)
and two unbalanced (channels six and seven) stereo
headphone outputs. The unbalanced outputs are able
to drive up to 10 headphones (without the need for an
external headphone amp), the balanced outputs will need
to be connected to a headphone amp.
Mix Insert, 2TrK 1,2
Post 2254 balanced insert sends and returns appear on
the first four channels of this connector. 2-Track 1, and
2-Track 2 inputs appear on channels five through eight.
Mix Out, 2254
There are two separate mix outputs on the
Series 75,
Modern and Retro. See Modern Output Stage and Retro
Output Stage for details. Modern Mix Outputs appear
on channels one and two. Retro Mix Outputs appear on
channels three and four.
Connect these to available interface inputs or a patch bay
as your Stereo Mix Outs. The balanced external inputs to
the 2254 Compressors appear on channels five through
eight.
Group Outputs/Ins send
If Group Outputs (balanced) are desired, these should be
connected to available DAW inputs. These outputs can
also act as Group Insert Sends, in which case connect
these to male XLR connectors or a patch bay.
stem Out
The Stem Outputs carry the eight Group signals post-
fader. Recommended as inputs to your DAW, and useful
for stem mixing.
Daw/Ins return
Extra DAW outputs could be connected here to achieve a
further eight inputs of monitoring. However, if the Group
Outputs/Ins send connector was used as Insert Sends,
use these as your Group Insert Returns.
