Neumann KMR 81i Operating Instructions Manual Download Page 6

10

11

6. Einige Hinweise zur Pflege von

Mikrophonen

Staubschutz verwenden: Mikrophone, die nicht im Ein-
satz sind, sollte man nicht auf dem Stativ einstauben
lassen. Mit einem Staubschutzbeutel (nicht fusselnd)
wird dies verhindert. Wird ein Mikrophon längere Zeit
nicht verwendet, sollte es staubgeschützt bei norma-
lem Umgebungsklima aufbewahrt werden.

Popschutz verwenden: Ein Popschutz hat nicht nur die
Aufgabe, bei Gesangsaufnahmen die Entstehung von
Poplauten zu verhindern. Er vermeidet auch effizient,
dass sich von der Feuchtigkeit des Atems bis hin zu
Essensresten unerwünschte Partikel auf der Membran
ablagern.

Keine überalterten Windschutze verwenden: Auch
Schaumstoff altert. Das Material kann brüchig und krü-
melig werden. Anstatt das Mikrophon zu schützen, kann
er dann zur Verunreinigung der Mikrophonkapsel füh-
ren. Überalterte Windschutze also bitte entsorgen.

Funktionstest: Moderne Kondensatormikrophone neh-
men durch lautes Ansprechen keinen Schaden. Zur
Kontrolle, ob ein Mikrophon angeschlossen ist und
funktioniert, sollte man es dennoch nicht anpusten oder
anpoppen, da dies einem akustischen Signal von mehr
als 140 dB (!) entsprechen kann. Normale Sprache ge-
nügt zum Funktionstest völlig.

Selbsthilfe kann teuer sein! Leider kommt es doch vor,
dass durch eine Selbstreparatur mehr beschädigt als
behoben wird. Insbesondere das Reinigen verschmutz-
ter Kapseln erfordert viel Erfahrung und die Hand ei-
nes Fachmanns. Der Lackschutz auf Platinen zeigt u.a.
an, dass dort nicht gelötet werden darf. Einige Bautei-
le sind speziell selektiert und können nicht durch Ma-
terial von der Stange ersetzt werden. Um unnötige Kos-
ten zu vermeiden, empfiehlt sich die Einsendung an
unsere Vertretungen oder an uns.

Inspektion durchführen lassen: Regelmäßiges Durchche-
cken des Mikrophonbestands, wie es einige Schauspiel-
häuser und Rundfunkanstalten praktizieren, kann bei
der Früherkennung von Schäden helfen. Leichte Ver-
schmutzungen lassen sich eher beseitigen, als eine un-
trennbar in die Membran eingebrannte Nikotinschicht.
Insbesondere bei Mikrophonen im Verleih und in ver-
unreinigenden Umgebungen empfiehlt sich die regel-
mäßige Kontrolle, deren Kosten im Vergleich zu einer
aufwendigen Reparatur sehr gering sind.

6. Hints on Microphone

Maintenance

Use a dust cover: Microphones not in use should not
be left on the stand gathering dust. This can be pre-
vented by the use of a non-fluffy dust cover. When
not in use for a longer period, the microphone should
be sealed against dust and stored under standard cli-
matic conditions.

Use a pop screen: A pop screen not only prevents
the occurrence of plosive pop noises in vocal record-
ings, but also efficiently prevents unwanted particles,
from respiratory moisture to food remnants, from set-
tling on the diaphragm.

Avoid the use of old wind shields: As the foam mate-
rial of a wind shield ages it can become brittle and
crumbly. Instead of protecting the microphone, an old
wind shield can thus lead to soiling of the microphone
capsule. Therefore please dispose of worn-out wind
shields.

Function testing: Although modern condenser micro-
phones are not harmed by high sound pressure levels,
one should under no circumstances use a pop-test to
check whether the microphone is connected and the
channel on the mixing console is pulled up, since this
can result in sound pressure levels of over 140 dB! Nor-
mal speech is quite sufficient for function testing.

Do-it-yourself repairs can be expensive! Unfortunate-
ly, do-it-yourself repairs sometimes do more harm than
good. Cleaning soiled capsules in particular requires
considerable experience and an expert touch. The pro-
tective lacquer on circuit boards indicates, among other
things, places which must not be soldered. Certain
components are specially selected and cannot be re-
placed by standard parts. To avoid unnecessary ex-
pense, we recommend sending defective microphones
to us or our representatives for servicing.

Regular inspections: Sending in microphones regularly
for inspection, as practiced by some theaters and
broadcasting corporations, can aid in the early detec-
tion of damage. Slight soiling can be removed much
more easily than a nicotine layer inextricably bonded
to the diaphragm. Regular inspections are particularly
to be recommended for microphones which are rent-
ed or are used in dusty or smoky environments, since
the costs are low in comparison with the cost of a
major overhaul.

WJ 81

WK 81

HG 82

oder/or SG 82

EA 82

oder/or H 82

a  = KMR 81 i

b  = KMR 81 i + WS 81

b

a

b

a

c

a  = KMR 81 i

b  = KMR 81 i + WK 81

c  = KMR 81 i + WK 81 + WJ 81

Summary of Contents for KMR 81i










Reviews: