Postfach 4063
Ust.-Id-Nr.:
Märkische Bank eG
170 143 100 (BLZ 450 600 09) Amtsgericht Iserlohn HRA 822
58663 Hemer
DE 812 45 68 50
Sparkasse Hemer
31 898 (BLZ 445 512 10) pers. haft. Gesellschafterin:
Telefon 0049-2372-9274-0
e-mail:
Dresdner Bank AG
704 282 600 (BLZ 445 800 70) Wolfgang Hellwinkel Verwaltungs GmbH
Telefax 0049-2372-3304
Postbank Dortmund 28 37 – 469 (BLZ 440 100 46) Amtsgericht Iserlohn HRB 2088
Geschäftsführer: Robin Hellwinkel
Technical data
Hot Dog with spits
art.-no. 13-50150 230 V / 1,2 kW
Hot Dog with spits on side
art.-no. 13-50152
230 V / 1,2 kW
Hot Dog ohne Stäbe
art.-no. 13-50160
230 V / 0,7 kW
Doppel Hot Dog
art.-no. 13-50162
230 V / 1,4 kW
Spießtoaster T6
art.-no. 13-50700
230 V / 1,0 kW
Spießtoaster T3
art.-no. 13-50701
230 V / 0,5 kW
Spießtoaster T6 lang
art.-no. 13-50703
230 V / 1,0 kW
Installation
The units with 230 volts are ready to be plugged into sockets which have been
secured with max. 16 A. Important: It is only allowed to connect max. 3,6 kW or 16 A
to each phase. If more than 3,6 kW has been connected, the fuse will immediately
disconnect the power supply.
Mounting
The unit has to be positioned on a place to enable the subsequent electrical
installation and maintenance of the unit. The appliances are neither suitable for
integration into a kitchen unit nor for mounting in line.
If the unit has to be set-up close to walls, partition panels, kitchen cabinets,
decorative edgings, etc. you have to make sure that these have not been made from
inflammable material. Otherwise they have to be insulated with a heat-resistant and
non-inflammable covering. Please adhere to the fire prevention regulations.
Before first use
Please read the operation manual carefully. Check the unit if any visible damages. If
any damages found please contact your customer service immediately.
There may not be damages at the power cord or plug. In this case please contact
your customer service to check the unit before using it.
Remove carefully the protective foil from the outside panels in order to avoid glue
residues remaining on the unit. Eventual glue residues may be removed by using an
appropriate thinner.
