Important!
Failure to ensure the correct assembly will
cause leakage of gas.
Important!
Make sure that the gas supply pressure of
the appliance obeys the recommended values.
Rigid connection:
Carry out connection by using metal rigid pipes (copper
with mechanical end).
Injectors replacement
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. With a socket spanner 7 remove the injectors and
replace them with the ones which are necessary
for the type of gas you use (see table in "Technical
Information" chapter).
4. Assemble the parts, follow the same procedure
backwards.
5. Replace the rating plate (it is near the gas supply
pipe) with the one for the new type of gas supply.
You can find this plate in the package supplied with
the appliance.
If the supply gas pressure is changeable or different
from the necessary pressure, you must fit an applicable
pressure adjuster on the gas supply pipe.
Adjustment of minimum level
To adjust the minimum level of the burners:
1. Light the burner.
2. Turn the knob on the minimum position.
3. Remove the knob.
4. With a thin screwdriver, adjust the by-pass screw
position.
A
A) The by-pass screw
• If you change from natural gas G20 20 mbar to liquid
gas, fully tighten the adjustment screw in.
• If you change from liquid gas to natural gas G20 20
mbar, undo the by-pass screw approximately 1/4 of a
turn.
Warning!
Make sure the flame does not go out
when you quickly turn the knob from the maximum
position to the minimum position.
Electrical connection
• Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.
• The appliance must not be connected with an exten-
sion cable, an adapter or a multiple socket. There is
a risk of fire.
• Do not let the power cable to heat up to a tempera-
ture of more than 90° C. The cable should be guided
by means of clamps fixed to the side of the cabinet,
in order to avoid any contact with the equipment be-
neath the cooktop.
• Make sure that there is access to the mains plug af-
ter the installation.
Electrical Requirements
Permanent electrical installation must agree with the lat-
est I.E.E. Regulations and local Electricity Board regula-
tions. For your own safety the installation must be done
by a qualified electrician (e.g. your local Electricity
Board, or a contractor who is on the roll of the National
Inspection Council for Electrical Installation Contracting
[NICEIC]).
The manufacturer refuses to be held responsi-
ble, if these safety measures are not abided
by.
Supply connections:
This hob has to be connected to 230 — 240 V ( 50 Hz)
electricity supply.
The hob has a terminal block which is marked as
follows:
•
L
— Live terminal
•
N
— Neutral terminal
•
or
E
— Earth terminal
Before carrying out the connection, make sure:
1.
The limiter valve and the electrical system can take
the appliance load (see the rating plate)
2.
The supply system is equipped with an efficient
earth connection in compliance with the current
standards and regulations
10
