11
TROUBLE! MATERIAL BEING SPRAYED IS SPLATTERING
WHAT’S WRONG?
WHAT TO DO…
Viscosity of material is too high.
Thin material per manufacturer recommendation.
Set at too high volume at very beginning.
Set flow rate at lower as start.
Paint not been stirred thoroughly.
Stir the material thoroughly.
TROUBLE! ATOMIZATION IS TOO COARSE
WHAT’S WRONG?
WHAT TO DO…
Viscosity of material too high.
Thin material per manufacturer recommendation.
Flow control knob setting too high.
Decrease flow control setting.
Material accumulated /clog inside nozzle.
Clean.
Air inlet blocked.
Clean or change air filter.
Canister loose.
Screw canister tightly in place.
TROUBLE! SPRAYER PULSATES.
WHAT’S WRONG?
WHAT TO DO…
Air filter clogged.
Clean or change air filter.
Material in canister almost empty.
Refill canister.
Canister loose.
Screw canister tightly in place.
TROUBLE! SPRAY MATERIAL DOES NOT COVER PROPERLY
WHAT’S WRONG?
WHAT TO DO…
Flow control knob setting too low.
Increase flow control setting.
Clearance to target area too large.
Reduce spray distance.
Too few spray paths sprayed over target area. Apply more spray paths sprayed over target
area.
Viscosity of material too high.
Thin material per manufacturer recommendation.
Have you tried the recommendations above and are still having problems?
In the United States, to contact to a customer service representative, mail our Technical
Service at [email protected] 24/7 or Facebook Page NEU MASTER TOOL. We will
get back to you within 24 hours.
