Maintenance
Trouble Shooting
After using for a period of time, you should check if the
filter is dirty or not. If it is excessively dirty, you need to
replace the filter with the following steps.
1. Remove the battery off the spray gun, and then remove the
filter guard with screw driver.
Problem description
A. Spray with low flow rate or no spray
B. Spraying material drips
C. Bad atomization
D. Spraying fluctuation
E. Hanging phenomenon of spray material
F. Over spraying
G. Spray pattern too thin
2. Remove the dirty filter and replace it with a new one.
3. Reinstall the filter guard.
Never operate the spray gun without a filter! The dirt will
be sucked into the appliance and cause a damage.
Reasons
1. Nozzle clogged
2. Suction tube clogged
3. Flow regulator set in low position
4. Suction tube loose
5. Tank loose
6. Filter clogged
1. Nozzle loose
2. Nozzle damaged
3. Nozzle seal damaged
4. Spraying material accumulated in nozzle
1. High viscosity of spray material
2. Highflow rate of spray material
3. Flow regulatorset high position
4. Nozzle clogged
5. Filter clogged
6. Low pressure build-up in the tank
1. Spray material is not enough in tank
2. Filter clogged
1. Spray too much material
1. Short distance between spray gun and surface
2. High flow rate of spray material
1. Move the spray gun too fast
Solutions
1. Clean the nozzle
2. Clean the suction tube
3. Adjust the flow regulator
4. Tighten the suction tube
5. Tighten the tank
6. Replace the filter
1. Tighten the nozzle
2. Replace the nozzle
3. Replace the nozzle
4. Clean the nozzle
1. Dilute the spray material
2. Increase the flow rate
3. Adjust the flow regulator
4. Clean the nozzle
5. Replace the filter
6. Tighten the tank
1. Refill the spray material
2. Replace the filter
1. Increase the flow rate or move the spray
gun faster
1. Increase the distance
2. Decrease the flow rate
1. Increase the flow rate or move the spray
gun slower
9
Filter
Summary of Contents for NSG0060-18
Page 10: ......
