3
ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
3. TAPE ON DOOR: "PROXIMITY READER" TEMPLATE (WI2098)
Remember,
the
Proximity Reader
is always located on the outside
("unprotected" side) door surface.
Fold and place the template (WI2098) on the
outside door edge
(see arrow
in Fig. 3 for an example). Align the template with the "
HORIZONTAL CEN-
TER LINE OF LEVER
" as shown on the template. Tape the template in
place.
4. MARK TEMPLATE "PROXIMITY READER" HOLES
On the outside door surface, mark the two holes for the
Proximity Reader
mounting screws.
Mark the center of the 5/8" diameter thru-hole (used for the
Cylindrical Lock Motor Wire
,
Proximity Reader
and
Door
Contact Sensor
wires).
TIP:
Take special notice of this
5/8" diameter thru-hole
, as it is an essential hole for this installation and is refer-
enced several times throughout these instructions.
FIG. 3: EXAMPLE OF OUTSIDE DOOR
EDGE (ARROW)
FIG. 4. CLOSE UP OF WI2098 TEMPLATE FOR THE "PROXIMITY READER"
