NTI 4K HDMI EXTENDER OVER HDBASE-T
2
MATERIALS
Materials supplied with this kit
:
NTI Transmitter and Receiver
2 x 100-240VAC, 50 or 60Hz-5VDC/2A AC Adapter
3-Pin wire terminal connector for RS232
URL Slip with path to this manual
Materials
Not
supplied but
REQUIRED:
Use HD-xx-MM to connect an HDMI source or display.
o
Max HDMI cable length: 30 feet.
Use CAT6/6a/7 (CATx) straight through cables for TIA/EIA 568B wiring terminated with standard RJ45 connectors.
Cables can be purchased from Network Technologies Inc by calling (800) 742-8324 (800-RGB-TECH) in the US and Canada or
(330) 562-7070 (worldwide).
Hardware Requirements
DVD player, Blu-Ray player,media receiver, or any PC with HDMI output ports
HDMI or DVI display device.
Note: If using a DVI-only display device, the video source must also be DVI.
PREPARATION FOR INSTALLATION
Locations should be chosen for the monitors, mice, and keyboards that also have space to connect the Remote and Local
Units within the distance provided by the cables. If extension cables are needed, contact NTI for the cables required.
The CAT6/6a/7 cable must be run to the locations where the Remote and Local Units will be connected. Be careful to route
the cable away from any sources of magnetic fields or electrical interference that might reduce the quality of the video signal
(i.e. AC motors, welding equipment, etc.).
All cables should be installed in such a way that they do not cause stress on their connections to the equipment. Extended
lengths of cable hanging from a connection may interfere with the quality of that connection. Secure cables as needed to
minimize this.
Properly shut down and disconnect the power from the CPU and monitors to be separated. If other equipment is involved
whose connections are being interrupted, be sure to refer to the instruction manuals for that equipment for proper
disconnection and re-connection procedures before proceeding.
Note: CATX connection cable used between NTI XTENDEX Series Local and Remote or any XTENDEX Series products
should not be run underground, outdoors or between buildings.
WARNING: Outdoor or underground runs of CATx cable could be dangerous and will void the warranty.
WARNING: Never connect the XTENDEX to an Ethernet card, Ethernet router, hub or switch or other Ethernet RJ45
connector of an Ethernet device. Damage to devices connected to the Ethernet may result.
