ASI-IP-GTW User's Manual
Page
27
To select a page, just click on the tab of the page you want to view.
Main tab (page)
Sub-tab
Description
Current alarms
The current status of the unit is shown. The page
shows pending alarms together with information
about when the alarm appeared and the severity level
of the alarm.
Status
Alarm log
The alarm log shows past alarms. Current alarms are
not shown on alarm log.
This gives information about the serial number and
software version of the unit. In addition, the user can
assign a name to the unit. The user can also change
the operation mode (IP Transmit , IP Receive or both)
or manually reset the device from this page.
Network
This is where IP address, subnet mask and default
gateway is defined for management interface and
data interface. In addition, for the data interfaces, the
Advanced tab provides configuration of in-band
management. The SFP tab provides information
about the SFP.
Time settings
Set SNTP server address. Current time is shown if
valid SNTP server is already defined.
Device Info
Alarms
Provides a list of all alarms and configuration of
severity level for the alarm events.
SNMP
Set Trap Destination Servers.
Ping
A page offering an interface to check for connectivity
by pinging a remote host.
Security
Enable or disable password protection, and change
password.
RIP-2
Show status, and change parameters for the Routing
Information Protocol
This is where each input is configured
Main
This is where the main parameters of each input are
configured. In addition, status of each stream is
shown.
FEC
This is where the FEC parameters are configured.
IP TX
Ethernet
This is where VLAN tagging, and Static MAC is
configured.
Ping
This is where Ping parameters for the IP channel is
configured.
IP RX
This is where the outputs are configured.
Main
This is where the main parameters of the outputs are
configured.
FEC
This is where the FEC parameters are configured.
Ethernet
This is where VLAN tagging, and Static MAC is
configured.
Ping
This is where Ping parameters for the IP channel is
configured.
Advanced
Advanced parameters related to buffer regulator.
Network
Overview of IP addresses UDP ports and bitrates.
Save/Load
Save and load of configurations.
