Modular Analog Audio Router
Rev. 8
3.3.1
Module insertion
In order to insert a power supply module one must insert the module via the
special plastic guide rails into its position. Once the module is inserted, fix the
module by lifting up the handle on the front and pushing it to the upright
position.
3.3.2
Module removal
In order to remove a power supply module, one must pull down the handle
on the front downwards to a horizontal position, and pull the module out
with the bar on top of the power module.
3.3.3
How to connect power to the Modular Analog Audio Router
There are two power connectors on the back of the frame. Both of these
connectors are for AC mains connection.
Use an IEC 320 connector to connect AC mains to the Modular Analog Audio
Router frame.
If the frame is equipped with a single power supply module, only one AC
mains connection is used. However, if the frame is equipped with dual,
Note:
There is a switch on the right hand side of the power supply module that
selects mains voltage. The mains voltage can be either 110VAC or 230VAC.
This switch
must
be set in the correct position, depending on the mains
voltage on the router’s site.
Failing to select correct AC mains voltage properly may damage the
Power Supply Unit.
15