10
Example#3
based on MinTime = 15 Minutes, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange= 0.1V.
MaxTime
sleeping sleeping
...
0H
15
th
M
30
th
M
45
th
M 1H
1H 10
th
M
1H 25
th
M 1H 40
th
M 1H 55
th
M
2H 10
th
M
Notes :
1)
The device only wakes up and performs data sampling according to MinTime Interval. When it is sleeping, it does not
collect data.
2)
The data collected is compared with the last data reported. If the data variation is greater than the ReportableChange value,
the device reports according to MinTime interval. If the data variation is not greater than the last data reported, the device
reports according to MaxTime interval.
3)
We do not recommend to set the MinTime Interval value too low. If the MinTime Interval is too low, the device wakes up
frequently and the battery will be drained soon.
4)
Whenever the device sends a report, no matter resulting from data variation, button pushed or MaxTime interval, another
cycle of MinTime/MaxTime calculation is started.
7. Installation
The device needs to be installed when it is powered off and the detected building/pole is in static status. It is recommended to
install the device horizontally. After the fixation is completed, please power on the device. The device performs offset calibration
after it has joined the network for one minute. The device needs a period of time to collect the three-axis tilt angle and battery
voltage of the detected building/telephone pole, and to make reference for the activity threshold, the inactive time, and whether
the building/telephone pole is tilted. The specific configuration depends on the actual situation.
Note:
After the device is turned on, it must be placed horizontally for one minute before using.
(The purpose is that the device will automatically perform the offset calibration to reduce the error of the detection result.)
Wakes up and
collects data
REPORTS 3.6V
Wakes up and collects data
3.5V |3.5-3.6|=0.1
REPORTS 3.5V
Wakes up and
collects data
3.5V
Does not report
Wakes up and
collects data
3.5V
Does not report
Wakes up and
collects data
3.5V
Does not report
Wakes up and
collects data 3.5V
Does not report
Wakes up and
collects data
3.5V
Does not report
Wakes up and
collects data
REPORTS 3.5V
Wakes up and
collects data
3.6V
Does not report
Users push the button,
REPORTS 3.5V.
Recalculate MaxTime.
