NT-1228BC
V18.7.12
Quick Setup Guide
This model can work both via USB cable or via bluetooth.
Connection Mode
Working via USB cable
Get Started
: Connect scanner with your device via USB cable. If you use US keyboard, it's a plug and play
model. If you use other type of keyboard , please refer to below "keyboard language type" to set the
keyboard language before use it.
Working via Bluetooth
Get Started
:
After you connect the bluetooth with your device (please refer to the section of "bluetooth
connection" from this manual) then you can start to use it. (US keyboard by default) If you use other type of
keyboard , please refer to below "keyboard language type" to set the keyboard language before use it.
Low voltage Alarm
:
Scanner will make 2x beeps to remind you that it's under low voltage. Plug the USB cable
to charge power for it.
If you want to have other configurations please refer to below programming barcodes.
Firmware Version:
Read below command barcode to check scanner firmware version.
Check Scanner Version
Below programming barcodes are applied for version
≥
NT_ZNCWBSDk8815
Barcode Programming
Netum barcode scanners are factory programmed for the most common terminal and communications
settings. If you need to change these settings, programming is accomplished by scanning the bar codes in this
guide. An asterisk (*) next to an option indicates the default setting.
Summary of Contents for NT-1228BC
Page 30: ......
