[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Resetting Parameters to
Default Values
[ENG] [2PWR,v2SMS] Resetting Parameters to Default Values
–
•
•
•
•
•
•
•
•
•
[ENG] [2PWR,v2SMS] Resetting Parameters to Default Values
Resetting parameters of a device to default values is necessary in the next cases:
login and/or password for accessing a web interface of a device is lost;
no information about a current IP address of a device;
in certain cases after updating firmware of a device
This procedure sets all customizable parameters of a device to default values (IP address, access filters, user name,
password and other settings).
device without a built-in battery):
switch off power of a device;
press the reset button «Reset»;
switch on power of a device keeping the «Reset» button pressed for 15-20 seconds;
release the button, all parameters of a device are reset to default values
device with a built-in battery):
press and keep the «Reset» button pressed for more than 5 seconds (use a pen/stilys/pencil, etc.);
release the «Reset» button, CPU LEDs near Ethernet ports will blink, all parameters of a device are reset to
default values
Short-term clicking the «Reset» button will reboot a device (for a
device with a
built-in battery).
On default, a device has the next parameters:
