[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Connecting, Installing, and
Initial Configuration of a Device
[ENG] [2PWR,v2SMS] Connecting, Installing, and Initial Configuration of a Device
–
A device is connected and ready to work.
A device that has been purchased right now or a device for which a procedure of resetting parameters to
default values has been performed
Resetting Parameters to Default Values
configuration of network addresses and parameters of load control
. After this, a device can be installed into
an existing network. Its further configuration may be performed by using a remote access to a device. More
detailed information about a configuration can be found in the document
Get a Document with a Firmware Description?
Important! It is not recommended to connect real network and computer equipment to power sockets at
the first switching on and familiarizing with the operation logic of a device. Frequent cycles of switching on/
off may cause equipment failure. During the time of familiarizing with a device, it is possible to conect an
indifferent load (for example, a table lamp) to power sockets or track a power supply status on power
sockets by glowing of corresponding LEDs.
