Motorola Netopia® Router CLI Commands 2-57
diffserv
rule
id
priority
[
off
|
assure
|
expedite
]
This command allows you to specify the priority for the rule
id
:
off
,
assure
, or
expedite.
This is the Quality of
Ser vice setting for the rule, based on the TOS bit information. The following table outlines the TOS bit settings
and behavior:
diffserv
rule
id
direction
[
outbound
|
inbound
|
both
]
This command allows you to specify the
direction
of the flow:
outbound
,
inbound
, or
both
. For TCP or UDP
protocols, you can optionally specify a range of por ts.
diffserv
rule
id
start-port
[
0
-
49151
]
This command allows you to specify the star ting por t in the range for the rule
id
for TCP or UDP protocols.
diffserv
rule
id
end-port
[
0
-
49151
]
This command allows you to specify the ending por t in the range for the rule
id
for TCP or UDP protocols.
diffserv
rule
id
inside-ip
x.x.x.x
This command allows you to specify the inside IP address for the rule
id
. For outbound flows, specify an IP
address on your LAN. For inbound flows, this setting is ignored.
diffserv
rule
id
outside-ip
y.y.y.y
This command allows you to specify the outside IP address for the rule
id
. If you want traffic destined for and
originating from a cer tain WAN IP address to be controlled, enter the IP address here. If you specify all-zeroes,
the outside address check is ignored.
For outbound flows, the outside address is the destination IP address for traffic; for inbound packets, the
outside address is the source IP address.
QoS Setting
TOS Bit Value
Behavior
off
TOS=000
This custom rule is disabled. You can activate it by selecting one of
the two settings below. This setting allows you to pre-define flows
without actually activating them.
assure
TOS=001
Use normal queuing and throughput rules, but do not drop packets
if possible. Appropriate for applications with no guaranteed deliver y
mechanism.
expedite
TOS=101
Use minimum delay. Appropriate for VoIP and video applications.
