NetModule NB224x, User Manual

Page: 5 / 99

User Manual NetBox Wireless Router
5/99
4-Jan-10
manual_netbox_e
1 Introduction
Thank you for purchasing NetBox Wireless Router from NetModule. This chapter gives you an introduction to
NetBox Wireless Router. The following chapters describe the installation and the configuration.
1.1 Safety Instructions
The NetBox Wireless Router must be used in compliance with any and all applicable international and na-
tional laws and in compliance with any special restrictions regulating the utilization of the communication
module in prescribed applications and environments.
To prevent possible injury to health and damage to appliances and to ensure that all the relevant provisions
have been complied with, use only the original accessories. Unauthorized modifications or utilization of ac-
cessories that have not been approved may result in the termination of the validity of the guarantee.
The NetBox Wireless Routers must not be opened. Only the replacement of the SIM card is permitted.
Voltage at all connectors of the communication module is limited to SELV (Safety Extra Low Voltage) and
must not be exceeded.
For use with certified (CSA or equivalent) power supply, which must have a limited and SELV circuit output.
The NetBox is designed for indoor use only. Do not expose the communication module to extreme ambient
conditions. Protect the communication module against dust, moisture and high temperature.
We remind the users of the duty to observe the restrictions concerning the utilization of radio devices at pet-
rol stations, in chemical plants or in the course of blasting works in which explosives are used. Switch off the
communication module when traveling by plane.
When using the communication module in close proximity of personal medical devices, such as cardiac
pacemakers or hearing aids, you must proceed with heightened caution.
If it is in the proximity of TV sets, radio receivers and personal computers, NetBox Wireless Router may
cause interference.
It is recommended that you should create an approximate copy or backup of all the important settings that
are stored in the memory of the device.
You must not work at the antenna installation during a lightning.
Always keep a distance bigger than 40cm from the antenna in order to reduce your exposure to electromag-
netic fields below the legal limits. This distance applies to Lambda/4 and Lambda/2 antennas. Bigger dis-
tances apply for antennas with higher gain.
Adhere to the instructions documented in this user‟s manual.