Get Started
10
AC1200 WiFi Range
Extender
Use the Extender in Extender Mode
Place the extender, apply power, and connect the extender to your WiFi network.
Note:
You can also use the extender as a WiFi access point and create a
new WiFi hotspot by using a wired Ethernet connection. See
Place the Extender and Apply Power
To place the extender and apply power:
1.
Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup process.
2.
Plug the extender into an electrical outlet.
3.
Wait for the Power LED to light amber and then turn green.
If the Power LED does not light, press the
Power On/Off
button on the side of the
extender.
Connect to an Existing WiFi Network
To extend the range of your WiFi network, you must connect the extender to your existing
WiFi network. You can do this in one of two ways:
•
Connect with WPS
. For more information, see
•
Connect with the NETGEAR installation assistant
. For more information, see
With the NETGEAR Installation Assistant
Connect With WPS
Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network without typing the network
name and password.
Note:
WPS does not support WEP network security. If you are using WEP
security, follow the instructions in
12.
To use WPS to connect the extender to your WiFi router:
1.
Press the
WPS/Mode
button on the extender for less than five seconds until the
WPS/Mode LED blinks.
