NETGEAR AirCard 778S, User Manual

Page: 24 / 30

AirCard 778S Mobile Hotspot User Guide
24 2400364
Failure to observe this instruction may lead to suspension or denial of cellular tele-
phone services to the offender, legal action, or both.
Some airlines may permit the use of cellular phones while the aircraft is on the
ground and the door is open. The mobile hotspot may be used normally at this time.
• While operating a vehicle
The driver or operator of any vehicle should not use a wireless data device while in
control of a vehicle. Doing so detracts from the driver or operator's ability to con-
trol and operate the vehicle. In some countries, using such communications devices
while in control of a vehicle is an offence.
Caution: Unauthorized modifications or changes not expressly approved by NETGEAR, Inc. could
void compliance with regulatory rules, and thereby your authority to use this device.
Proper Battery Use and Disposal
Note: Improper battery use may result in a fire, explosion, or other hazard.
To ensure safe and responsible battery use:
• Do not open, disassemble, puncture, crush, bend, or shred.
• Do not expose to water or other liquids, fire, explosion, or other hazards.
• Use the battery only in the mobile hotspot.
• If using with a charger, use only the charger supplied with the mobile hotspot.
• Do not short circuit the battery.
• When replacing a battery, use the same model of battery that was supplied with
the mobile hotspot.
• Follow local regulations when disposing of a used battery.
• Avoid dropping the mobile hotspot or the battery. If dropped and you suspect
damage, take it to a service center for inspection.
Regulatory Information for North America
FCC ID: PY3AC778S
Caution: The AirCard 778S Mobile Hotspot was tested for typical body-worn operations. A
minimum separation distance must be maintained between the user's body and the Hotspot: 1 cm
to comply with the RF exposure requirements in the U.S. for FCC exposure requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.