| Industrial
IoT
11
NTC-100 4G LTE Cat M1/NB1 Industrial IoT Serial Modem
Powering the NTC-100 via Y-cable
The included Y-cable features a breakout cable providing a DC Jack. Connect the
Serial plug to a Serial port on your device (e.g. computer) and then connect a 4.5-
36V power source to the DC Jack to power the unit. Connect the 10-pin plug into
the 10-pin connector on the NTC-100 serial modem.
After powering up, the NTC-100 serial modem is ready to establish a serial
communication link. See the next section for instructions on accessing the NTC-
100 serial modem via terminal emulator.
Configuring the NTC-100 via SMS
A full list of SMS commands used to control and configure the NTC-100 are
available in the User Guide.
