NetComm Wireless NTC-6200-01, User Manual

Page: 112 / 120

112
NetComm Wireless Intelligent M2M Router www.netcommwireless.com
Recovery mode
The Intelligent M2M Router features two independent operating systems, each with its own file systems. These two systems are referred to as 'Main' and 'Recovery'. It is always possible to use
one in order to restore the other in the event that one system becomes damaged or corrupted (such as during a firmware upgrade failure).
Both systems have Web interfaces that can be used to manipulate the other inactive system. The Intelligent M2M Router starts up by default in the Main system mode, however the router may be
triggered to start in recovery mode if desired.
To start the router in recovery mode:
1. Press and hold the physical reset button on the interface panel of the router for 5 to 15 seconds. When the LEDs on the front panel change to amber and countdown in a sequence,
release the reset button. The router then boots into recovery mode.
2. In your browser, navigate to http://192.168.1.1 . The router’s recovery mode is hardcoded to use this address regardless of the IP address that was configured in the main system.
The router’s recovery console is displayed.
Figure 105 - Recovery console
The recovery console provides limited functionality. Basic status information is available, as well as access to the System log for troubleshooting. The Application Installer can be used to upload
and install different firmware, allowing you to roll back to a previous firmware in the event that an upgrade fails. The Settings menu provides the ability to reset the router to factory default settings
and the Reboot tab allows you to perform a soft reboot of the router.