Netberg Aurora 710, Installation Manual

Page: 9 / 28

Hardware Installation
4
2.2. Installation using the Rubber Feet
When installing the switch in an area other than inside a switch rack, like on a desktop, rubber feet
can be attached to the bottom panel of the switch. The rubber feet cushion the switch, protecting
the casing from scratches, preventing it from scratching other surfaces, and preventing it from slip-
ping.
1. Install the switch on a flat surface that can safely support its weight.
2. The adhesive material is included on the rubber feet. Pull away the protective sticker of each
rubber foot and attach them to the switch bottom.
3. Make sure that there is proper heat dissipation from and adequate ventilation around the switch.
Leave at least 15 cm (6 inches) of space at the rear and 5 cm (2 inches) at the front of the
switch for ventilation.
Figure 2.1. Rubber standoffs placement
Do not place any heavy objects on the switch.