![NetApp DiskShelf14mk2 FC Hardware And Service Manual Download Page 52](http://html.mh-extra.com/html/netapp/diskshelf14mk2-fc/diskshelf14mk2-fc_hardware-and-service-manual_1669936052.webp)
46
Replacing a power supply in a disk shelf
Installing a power
supply
To install a power supply in a disk shelf, complete the following steps.
Attention
Do not use excessive force when sliding the power supply into the disk shelf.
You can damage the connector.
4
Use the handle to pull the power supply out of the disk shelf.
CAUTION
When removing a power supply, always use two hands to support its weight.
Step
Action
Step
Action
1
Put on the antistatic wrist strap and grounding leash.
2
If the power supply
CAM mechanism is...
Then slide the power supply in the
power supply bay...
In the middle of the rear
of the unit
And push the CAM mechanism levers
into place.
At the top of the rear of
the unit
1. Until you hear the power supply
connect with the connector inside
the disk shelf chassis.
2. Raise the handle and push it into
place.
3. Using your thumb and index finger,
press the CAM mechanism levers
toward each other to engage the
power supply into place.
Summary of Contents for DiskShelf14mk2 FC
