NetApp DiskShelf14mk2 FC, Hardware And Service Manual

Page: 5 / 90

Safety Information (Sicherheitshinweise) v
Safety Information (Sicherheitshinweise)
Safety rules
All products are Class 1 laser devices, except the NVRAM5 cluster media
converter, which is Class 1M. You must follow these safety rules when
working with this equipment:
DANGER
Failure to follow these directions could result in bodily harm or death.
◆
When using an NVRAM5 cluster media converter, the system must be
installed in a restricted access location.
◆
Switzerland only—for FAS900, GF900, R200, and C6200 systems:
This equipment relies on fuses/circuit breakers in the building installation
for overcurrent protection. Each power supply must receive power from a
separately dedicated outlet with a 10A fuse/circuit breaker.
◆
When installing disk shelves and a system into a movable cabinet or rack,
install from the bottom up for best stability.
◆
DC-based systems must be installed in a restricted access location and the
two input power terminals for the DC power supply must be connected to
separate isolated branch circuits.
◆
To reduce the risk of personal injury or equipment damage, allow internal
components time to cool before touching them and ensure that the
equipment is properly supported or braced when installing options.
◆
This equipment is designed for connection to a grounded outlet. The
grounding type plug is an important safety feature. To avoid the risk of
electrical shock or damage to the equipment, do not disable this feature.
◆
This equipment has one or more replaceable batteries. There is danger of
explosion if the battery is incorrectly replaced. Replace the battery only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
For units with multiple
power cords
If your system or disk shelf has multiple power cords and you need to turn the
unit off, heed the following warning:
DANGER
This unit has more than one power supply cord. To reduce the risk of
electrical shock, disconnect all power supply cords before servicing.