g. Repeat these steps to install all of the drives.
2. Slide the drawer back into the drive shelf by pushing it from the center and closing both levers.
Attention:
Risk of equipment malfunction – Make sure to completely close the drive drawer by pushing both levers.
You must completely close the drive drawer to allow proper airflow and prevent overheating.
3. Attach the bezel to the front of the drive shelf.
4. If you have powered down one or more shelves, reapply power:
If you...
Follow these steps...
Replaced a drive drawer in a controller
shelf without Drawer Loss Protection
a. Turn on both power switches on the controller shelf.
b. Wait 10 minutes for the power-on process to complete.
c. Confirm that both fans come on and that the amber LED on the back of the fans is off.
Replaced a drive drawer in an
expansion drive shelf without Drawer
Loss Protection
a. Turn on both power switches on the drive shelf.
b. Confirm that both fans come on and that the amber LED on the back of the fans is off.
c. Wait two minutes before applying power to the controller shelf.
d. Turn on both power switches on the controller shelf.
e. Wait 10 minutes for the power-on process to complete.
f. Confirm that both fans come on and that the amber LED on the back of the fans is off.
Copyright information
Copyright
©
1994–2017 NetApp, Inc. All rights reserved. Printed in the U.S.
No part of this document covered by copyright may be reproduced in any form or by any means—graphic, electronic, or
mechanical, including photocopying, recording, taping, or storage in an electronic retrieval system—without prior written
permission of the copyright owner.
Software derived from copyrighted NetApp material is subject to the following license and disclaimer:
20
