(A pulsing LED blinks steadily at a rate of once per second. A flashing LED blinks at a more rapid, less constant rate.)
2.0 E1 PARAMETERS
Parameters common to all of Net to Net's interface modules are defined in Net to Net's management user
guides; refer to the NMS Management User Guide (
http://www.nettonet.com/support/docs/210-
0000048
) and/or the CLI Management User Guide (
http://www.nettonet.com/support/docs/210-
0000052
). Parameters specific to the EIM2000 are outlined below.
2.1 Parameter Defaults
No configuration is necessary for the EIM2000 to operate at default settings.
AL (Alarm)
no
illumination
E1 is operational
An established E1 link has no alarm indications
and is operational UNLESS the LK LED remains
unlit as well, in which case the E1 port has
LOS
.
solid amber
Remote Alarm Indication (RAI)
An outgoing connection has been
lost; the remote E1 modem is not
receiving any data from the E1 port.
The remote E1 modem has lost its incoming
connection and has
LOS
.
pulsing
amber
Alarm Indication Signal (AIS)
An indirect connection has been lost;
the E1 port may no longer be
receiving data from the remote E1
modem.
The remote E1 modem has lost a connection
with an intermediate device and has
LOS or
RAI
.
Parameter
Default
Clock Source
Local - provider mode
Loop - subscriber mode
Flood
Uplink
Frame Type
Cyclic Redundancy Check (CRC)
IP Range 1
0.0.0.0 - 255.255.255.255
IP Range 2
0.0.0.0 - 0.0.0.0
Line Code
High Density Binary 3 (HDB3)
Priority
0
Protocol
ALL
Speed (Single Line) 1,984 kbps
VLAN
0 - 0
VLAN Back-bone
0
210-0000054 rev0
2
EIM2000 User Guide Page 17 of 20
