Installation Instruction
20201210/ML/01
Nestor Optimus DB Reducers
Page 5 of 6
©
Nestor Cables Ltd. 2020.
10.12.2020
The information contained within this document must not be copied, reprinted or reproduced in any form, either wholly or in part, without the
prior written consent of Nestor Cables Ltd. The information is believed to be correct at the time of issue. Nestor Cables Ltd. reserves the right
to amend this specification without notice. This specification is not contractually valid unless specifically authorized by Nestor Cables Ltd.
•
In order to disconnect the microduct from the connector, make sure that the pressure has
been completely eliminated from the system before any operation.
•
First, remove the locking clip. If it is the first time the locking clip is removed, a small part of
it will be broken to identify that it is removed.
•
To disconnect the microduct, push the collet in the direction of the connector body and pull
the microduct outwards while keeping the collet pushed against the connector body.
•
Never press collets towards the body unless you need to separate the microducts from the
connector in an unpressurized line.
Product reuse
•
Nestor Optimus DB Reducers can be reused after checking that they are not damaged and
correctly working.
•
Even if the connector reuse is possible, it’s only recommended in case of maintenance. The
microduct network should never be built by reused connectors.
•
In case of connector reuse, the operator must verify reused components and carefully check
the correct functioning of the whole system.
•
In the case of reuse of a microduct, the part previously inserted into the connector must be
cut back and the whole line has to be re-verified.
•
It is necessary to follow all the instructions as a precaution, in the same way as for the first-
time installation.
Lubricants
•
In case of use with lubricants, it is the end user or customer responsibility to check the
chemical compatibility of the fluid with the construction materials of the connector.
•
Please contact our technical department if you would like to receive more information
regarding suggested lubricants.
Modifications
•
Do not disassemble or modify the individual products as this may cause product
malfunctions, leaks or failure.
•
In any case the tampering, modification or dismantling of the products invalidates the
guarantee.