GPS Personal Tracker User Manual V1.3
Page 6
To Receive Continuous Tracking Information
By sending the following SMS: “paM (0/1), xxx (S/M/H)” to the unit, the tracker will in
turn reply with one position message at a preset time interval. The unit will only SMS the
Authorized number “A1”
•
The combination; “M0” indicates being switched off, whereas “M1” indicates being
switched on. The letter “M” must be in capital.
•
The numbers where “Xxx” are situated displays the time interval in which the position
message will be relayed. It must always be three digitals (e.g.: 030S means 30S).
•
The letter “S” stands for second, “M” means minute, “H” indicates hour.
•
Hours (H) should always be less than 90. Seconds (S) and minutes (M) should at all times
be less than 255.
An example of this can be shown by sending an SMS of: “123456M1,030S” to the GPS Tracker.
This configuration will insure that a text message of the tracker’s position will be sent to the A1
Authorized number every 30 seconds. By sending an SMS of: “123456M0,030S” to the tracker
will switch off the continuous tracking function.
SOS Function
Pressing and holding down the SOS button for three seconds will transmit an SMS which reads
“
Help me!
” as well as the current position of the GPS Tracker to the A1, A2, and A3 authorized
numbers programmed into the unit
Along with this, the tracker has the ability to dial up all three authorized numbers. The tracker will
attempt to make contact with the A1 authorized number first. If this fails it will attempt to contact
A2. In the event that the A2 authorized number is not able to be connected the system will dial the
third number (A3). This process will continue until one of the authorized numbers is contacted and
two way communication is established between the GPS Tracker and one of the authorized
numbers.
Dialing Preset Numbers
Pressing the “CALL1” button for three seconds will enable the tracker to dial the preset number in
the “CALL1” slot. Likewise the number preset into the “CALL2” button can be contacted by
holding down the “CALL2” button for three seconds.
