Ness FGR006SRB, Product Installation Manual, Page: 8 / 78

5
Ness - IDTECK
2 . W IR IN G & IN ITIAL S E TTIN G
2-6-2.
Ness
505R initial setting
STAR 505R [F1]
M M /DD HH:M M :SS
Start Display
Enter into
Setup M ode
Enter
Default Master No
(00000000)
M ODE SELECTION
RF ONly
M ODE SELECTION
RF ONly
Display for M ode Selection
ENT
M ODE SELECTION
->RF ONly
COM M ID SETTING
Display for Set Address
ENT
COM M ADDRESS
00
ID REGISTRATION
ID[_ _ _ _ _ _]
PW _ _ _ _ TS_ _ RD_
ID Registed
Display for ID Registration
Display for finishing
Display for ID Delete
ENT
PIN Only
RF Only
RF + P/W
Scanning...
xxxxxxxx
PW _ _ _ _TS_ _RD_
ID DELETE
ENT
Enter Card No.
-> _ _ _ _ _ _ _ _
4 or 6 key : Left / Right move
2 or 8 key : Up / Down move
ENT : OK or Enter
ESC : Cancel or deactivate
RF Only : Card
RF + P/W : Card + P/W
Press Ent under COMM ADDRESS status and enter
address No(00 ~ 31)
RF Only, RF + P/W MODE :
Register Card & P/W
PIN Only : Register PIN (4 ~ 6digit)
Present card or enter 4~6 or 8 digit No. which
user wants to delete to delete ID.
PIN only mode : 4~6 digit No.
RF only, RF + P/W mode : 8 digit No.
RF Only, RF + P/W: Card Reading
PIN Only: Register PIN (4 ~ 6digit)
TS: Set Time Schedule (DEFAULT:00)
~ Set accessible time
RD: Set Reader mode(DEFAULT:3)
1 ~ Use only main device
2 ~ Use only exit reader
3 ~ Use both reader
a. S E T MODE S E LE C T ION (S elect mode with 4 or 6 K ey)
b. S E T ADDR E S S (S elect mode with 4 or 6 K ey, E nter Address from Numeric K ey)
c. C AR D R E G IS T R AT ION (E nter F 3)
d. DE LE T E C AR D (E nter F 3, S earch with 4 or 6)
e. Hardware Initialization. (In case master card or ID is lost)
1. Please check if the back-up battery DIP switches are on the
backside of the device as the picture. If not, please set them on.
2. Connect three wires of pink, cyan and black color and
turn the power on
3. A message of “system initialization” is to be shown in LCD
4. Press “1” to choose “Yes” then “ system initialization
completed” message is to show in the LCD
5. Disconnect those three wires and wire them as normal
connection diagram as before
SETTING A DIP SW ITCH
Before After
ON ON
1 2 1 2