Nesco ES-08, Instruction Manual

Page: 4 / 12

2
English
PARTS
HOW TO ASSEMBLE YOUR ELECTRIC SKILLET
Remove all parts from the packaging.
1. Locate and remove Lid Knob from the packaging.
2. Place the screw through center hole of lid. The head of screw to inside of lid.
3. Place Protector Ring over screw threads on the outside of lid. Rough side of
ring facing glass.
4. Turn Lid Knob onto screw thread while pressing on head of screw.
5. Tighten screw until snug.
BEFORE FIRST USE
1. Read and follow all instructions and save for reference.
2.
Remove all packaging and labels.
3. Clean all parts following instructions in the ‘Care and Cleaning’ section.
4. Wipe the base with a damp cloth.
OPERATION
1. Place appliance on a fl at, heat resistant, stable surface in a ventilated area.
2. Make sure the temperature control is in OFF position. Insert control into inlet
on the side of skillet. Then insert plug into electrical outlet.
3. Adjust control to desired setting. NOTE: The signal light on control indicates
heat setting. When desired setting is reached, the light will turn off . It will
continue to cycle on and off during use to indicate heat setting is being
automatically maintained.
4. Preheat the skillet with the lid on for 10 minutes or until the indicator light
goes out. NOTE: The cooking temperatures listed in this user manual are
estimates. Adjust the cooking temperature slightly up or down to achieve the
results you prefer.
5. A steam vent is located on the glass lid. The steam vent allows steam to
escape while cooking with the lid in place. CAUTION: Escaping steam is
hot! Be careful while removing or lifting lid.
Handles Lid Knob
Temperature
Controller
Cooking Plate
Glass Lid