21
1
．
Soft positive/negative-limit is system alarm when the current coordinate over the value set. If
it is not used, you should set the parameter over the actual value.
2
．
Origin value of machine tool is coordinate value relative to reference point in mechanical
origin( use switch setting). If the machine tool do not set mechanical origin, you can set the origin
value of machine tool as zero.
3. The reference point is defined as start point of program machining, G92 will be produced
automatically when system running.
4.
Reversal clearance should fill diameter when fill the value of X axis.
2.5.3 Control parameter
Press
【
F4
】
and select, refer picture below:
1．
Machining speed limit
is set the max speed of G01,G02,G03. When program running, it will
execute in this mode by default. When the set speed(F) low the machining speed limit, actual
speed is according to F speed.
Adjust parameter settings
Soft positive limit
：
X 1500.000 Z 1500.000
Soft negative limit
：
X -1000.000 Z -1500.000
Machine tool origin
：
X 0000.000 Z 0000.000
Reversal clearance
：
X 0000.000 Z 0000.000
Cutter
Speed
Adjus
Contr
Syste
Save
Control parameter settings
Machining speed limit
：
01000
Ignition delay
：
00050
Preheat delay
：
01000
Cutting gun rising delay
：
00200
Cutting gun falling delay
：
00180
Speed
Adjus
t
Contr
ol
Syste
m
Save
www.EngineeringBooksPdf.com
