Neptune R450 MC, Installation And Maintenance Manual

Page: 37 / 104

Installation of the R450 MC
R450 Mini Collector Installation and Maintenance Guide 23
Installing a Large Pole Mount System
This section presents a table to be used to mount the R450 MC system
to a large pole.
To assemble and install the pole mount system, complete the
instructions contained in the following sections of this manual.
Mounting the RF Antenna to a Large Pole
Mount the RF antenna to a 3-inch to 16-inch (7.62 cm to 40.64 cm)
diameter pole by completing the following steps.
1 Mount the RF antenna to the pole the same as when mounting to a
stand. See “Attaching the RF Antenna Cable” on page 27.
However, use the 2-inch to 12-inch Snaplock clamps to mount the
antenna bracket to the pole as shown in Figure 29.
Figure 29 RF Antenna for a Pole
The instructions to mount the R450 MC system to a large pole are very similar
to the instructions for installing a stand system.
•
Please refer to “Mounting the R450 MC to a Large Pole” on page 24.
• Please note that information bullets, such as these, are included in
each section for special considerations added for the large pole
installation.
Table 4 Installing the R450 MC Large Pole Mount System
Complete Steps for...
1 “Mounting the RF Antenna to a Large Pole” on page 23
2 “Mounting the R450 MC to a Large Pole” on page 24
3 “Mounting the Battery Box to a Large Pole” on page 25
4 “Mounting the Solar Panel to a Large Pole” on page 26
RF
antenna