Neptun NPSTP-O 600, Operating Instructions Manual

Page: 11 / 116

- GB -
- GB -
11
Warnings used in these instructions
NOTE
Information for the purpose of clarification or for preventing possible damage to assets or to the environment.
Cross-references used in these instructions
 A reference to a figure, e.g. figure A.

Reference to another section.
Scope of delivery
 A Quantity Description
1 1 Pump with 5 m connection cable
2 3 Nozzle extension
3 1 Nozzle
4 1 Nozzle holder with nozzle attachment
5 1 Solar module
6 1 Ground stake set
7 1 Remote control
8 1 LED lighting with 5 m connection cable
Intended use
NPSTP-O 600, referred to as "unit", may only be used as specified in the following:

For creating a water fountain in a pond.

For operation with clean water.

Operate in accordance with instructions.
The following restrictions apply to the unit:

Never use the unit with fluids other than water.

Never run the unit without water.

Do not use for commercial or industrial purposes.

Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
How to proceed:

B
1. Assemble the nozzle unit and the LED lighting and fit onto the pump.
– Adapt the number of nozzle extensions used to the depth of the pond.
2. Connect the connection cables of the pump and LED lighting to the solar module. ( → Commissioning/start-up)
– Push each plug into the socket as far as possible to ensure that the connection is watertight.
3. Assemble the ground stake set and attach it to the solar module.
– Align the solar module such that the sockets with the connection cables point downwards.
4. Install the solar module so that it is exposed to direct sunlight.
– Recommendation: Align the solar module to the sun to ensure maximum energy yield.
5. Install the unit in the pond in a horizontal position on firm, sludge-free ground and ensure that it is completely cov-
ered with water.