12
Betriebsanleitung Neptun Massagestation Edelstahl V.20181005
precautions for building companies:
For sealing the plastic thread exclusively a Teflon tape must be used. All system components
must be mounted in the way that they are voltage free and free of contamination. In particular, the
seat of all the o-rings, union nuts, etc. must be checked to that effect.
You have to tighten the PG- gland hand-tight on the back of the wall penetration for the PN-but-
ton.
The pump must never run dry (which means without water), because otherwise the mechanical
seal will be damaged (loss of warranty).
The use in and around swimming pools or garden ponds is only permitted if they are built accor-
ding to local statutory regulations. In this regard please contact your Neptun expert or the local
bulding department
There are rules necessarily to be observed by ÖVE (VDE), as well as the local EW when installing
the system. The installation may exclusively be carried out by a licensed electrician.
In power line an all- pole seperator with a contact gap of at least 3 mm must be provided. Fur-
thermore a residual current circuit breaker with a rated leakage current of <= 30 mA must be pro-
vided.
Attention! Pay attention to the motor direction of rotation (direction of rotation arrow). The swit-
ching device must be installed in a place easily accessible and dry.
The air suction valve must be above the level of the water surface. In the shaft there must be a
sufficient sized drainage
Massagestation Edelstahl_A4 14.12.18 08:57 Seite 12