Nuvo-2400
User’s Manual
Copyright © 2015 Neousys Technology Inc. All Right Reserved.
Page 50 of 81
4.7 Connect DC Power to Nuvo-2400
Nuvo-2400 Series uses a 3-pin pluggable terminal block to accept from 8~25V DC power
input. It provides the way for directly wiring the DC power. To connect DC power via the
3-pin pluggable terminal block, please follow the steps listed below.
1. Make sure the external DC power supply is power off or disconnected before you wire
it to the pluggable terminal block.
2. Get the 3-pin pluggable terminal block from the accessory box. The terminal block fits
the wires with a gauge of 12~24 AWG.
3. Carefully identify the positive and negative contacts of your DC power supply and
pluggable terminal block. The polarities between DC power supply and terminal block
must be positive (+) to positive (+) and negative (-) to negative (-).
Figure 44: Wiring of DC Input Terminal Block
4. Push the terminal block to the DC input connector till it's firmly attached. Now you can
supply the DC power and operate your system.
Figure 45: System with DC Input Terminal Block
