KALYSO – KALYSO HY – KALYSO NV manual
10
2.5.2
Rear wheel (
Kalyso
and
Kalyso Hydraulique
model):
This operation should be performed by a professional; however, here is the procedure to follow.
Tool required: 19 mm open-ended spanner.
Dismounting the rear wheel:
Disconnect the motor (the connector is situated on the right side of the e-bike on the lower horizontal section
of the frame}.
Cut the Colson cable tie attaching the motor cable to the frame. Remove the right and left wheel nut covers.
Loosen the nuts. Remove the nuts and the wheel axle washers. Loosen the V-
Brake’s cable clamp to release
the pads and enable the removal of the wheel (for the
Kalyso
model).
Remove the chain from the wheel sprocket, while paying attention to how the chain swings.
Move the wheel forward to remove it from the frame and remove the chain from the wheel axle.
Mounting the rear wheel:
Take the wheel and place the chain on the small sprocket on the right-hand side, then place the wheel
between the brake pads (for the
Kalyso
model).
Insert the wheel axle backward into the housing on the left and right of the frame. Attach the washers and
the wheel nuts. Tighten the nuts by hand initially, until they make contact with the frame.
Centre the wheel in line with the frame and the mudguard. Check the centring and positioning in line with the
front wheel, as well as the positioning of the chain.
Screw on the wheel nuts on both sides without tightening them all the way. Check the positioning, centring
and position of the chain again.
Alternately and progressively tighten the wheel nuts on each side (max. tightening torque 30 Nm)
Replace the nut covers.
Reconnect the motor connection and replace the Colson cable tie on the frame.
NB: the connector is equipped with a keyed connection. Place the two pins so that they are facing each other
(follow the arrows).
Adjust the brake pads (
see
Chapter 2.3)
.
Position the two
pins correctly to
reconnect the
motor plug
