«Neomatica» Wireless sensor-immobilizer ADM33, edition 1.1 dd 11.11.2019
13
13)
Save the changes after settings. Otherwise the settings will return to initial values in
case of rebooting (power turn off). To save the settings use
wf
command – settings
record;
14)
Having recorded the settings, disconnect from the immobilizer. To do this click on
“Disconnect” in the upper-right corner.
General rules for writing and sending commands:
⎯
Only Latin alphabet characters are used in commands;
⎯
Lower case characters;
⎯
Commands are separated by SPACE;
⎯
Parameters are set using Latin letters and Arabic numerals
Having received a command, the immobilizer performs it and sends the response in a
message. If command parameters are beyond permissible limits the immobilizer changes
these parameters to the nearest permissible values. The immobilizer will not response the
command if it is impossible to change the parameters or the parameters are not enough.
4.2.3.1.
Reading of the immobilizer current settings
•
To read current parameters use command
rs.
The command sends response in the following form:
