30
Connection via Fuse Cord 3 pin cable.
- The cable must be connected according to the diagram in Section 1.4 hereof; besides, it must be connected to an
X-COP 9100s device.
- Set G-sensor and/or motion sensor sensitivity in Parking mode.
- Where the Parking mode settings show ON, the Parking mode activates as soon as ignition is off.
- When the Parking mode settings show time interval set (“X min”), the mode activates the same way as in a lighter
socket is used.
- When the Parking mode settings show OFF, the device disconnects as soon as ignition is off.
- Once the motor is started, the system switches to normal mode instantly.
- Where recording started before the motor starts, the Normal mode activates automatically once the emergency
recording is completed.
ATTENTION:
Parking mode only allows using the on-board network for a power source.
5.2. Recording in Parking mode
If there is a stroke when in Parking mode or any movement ahead the car is detected, the video file is recorded for 10
seconds before this event and 50 seconds after it; the file is saved to the “Parking” folder of the memory card.
Resolution of the records taken in Parking mode is as follows: 1920*1080 (Full HD)/1280*720 (HD) at 15 fps