9
IMPORTANT: Attempting to insert the memory card with a wrong side can
damage the device and the memory card itself. Make sure the memory card is
in correct position.
Warning:
Do not apply too much effort when installing the memory card in
order to avoid damage of the device. To install, insert MicroSD into the slot until
it is fixed (goes click); if necessary, use a needle to seat the card. To remove the
card, press on it until click and remove from the slot, use a needle if necessary.
В. Then connect the charger cable to Mini-USB connector located on the device
housing and inset the charger itself into connector of the cigarette lighter/ start
the car engine, the device will switch on automatically.
Switching On/Off
1. Automatic: the device automatically switches on upon startup of the car
engine and switches off when the engine stops. Upon startup of the car
engine (power is supplied to 12/24V car socket), the device automatically
starts recording. After the engine is switched off (power is disconnected
from 12/24V car socket), the device automatically stops recording and saves
the recorded files.
[ Operation ]
Preparation of the device
А. Installation of memory card. Switch
off the device before memory card
installation. Position MicroSD card
against the slot as shown on the figure
and insert till it goes click.
Card removal: carefully press the card
and then remove it from the slot.
