NEO STORMER QUAD, User Manual

Page: 3 / 35

P. 3
- Neo Stormer Quad English version
2. GETTING STARTED
Unpacking
• 1 x Stormer Quad RGBW LED Strobe
• 1 x Base Plate
• A Sweet Safety Cable, An Eyebolt & Set of
Mounting Brackets
• An Ever-So-Handy Power Cord
• This Lovely User Manual
Carefully
Check the shipping carton for damage that may
have occurred during shipping. If the carton ap-
pears to be damaged, carefully inspect your unit
for damage and be sure all accessories necessary
to operate the unit have arrived intact. In the
event damage has been found or parts are miss-
ing, please contact our customer support team for
further instructions. Please do not return this unit
to your dealer without first contacting customer
support at the number listed below.
Introduction
Congratulations, you have just purchased one of
the most innovative
and reliable lighting fixtures on the market today!
Please read and understand the instructions in this
manual carefully and thoroughly before attempting
to operate this unit, This manual contains impor-
tant information regarding safety protocol that
must be strictly adhered to at all times.
Powering Up
All fixtures must be powered directly off a switched
circuit and cannot be run off a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or
dimmer channel is used solely for a 0% to 100% switch.
AC Voltage Switch
Not all fixtures have a voltage
select switch, so please verify that the fixture you
receive is suitable for your local power supply.
See the label on the fixture or refer to the fix -
ture’s specifications chart for more information. A
fixture’s listed current rating is its average current
draw under normal conditions. Check the fixture
or device carefully to make sure that if a voltage
selection switch exists that it is set to the correct
line voltage you will use.
Warning!
Verify that the voltage select switch on
your unit matches the line voltage applied. Damage
to your fixture may result if the line voltage applied
does not match the voltage indicated on the volt-
age selector switch. All fixtures must be connected
to circuits with a suitable Ground (Earthing).
Getting A Hold Of Us
If something is wrong, please contact your dealer.
Disclaimer: The information and specifications
contained in this document are subject to change
without notice. We assumes no responsibility
or liability for any errors or omissions that may
appear in this user manual. We reserves the right
to update the existing document or to create a
new document to correct any errors or omissions
at any time. You can get the latest version of this
document from your dealer.
Safety instructions
Please read these instructions
carefully they include the important
information about the installation
usage and maintenance of this
products.