P. 5
English Version
| NEO STORMER 1200 IP
4· SIGNAL AND POWER CONNECTION
5· FUNCTION SETTING
MENU
LCD
DOWN
UP
ENTER
For the connection of control signals, 2-pin shielded
cables with a diameter not less than 0.5 mm must
be used between the fixture and the controller and
between the fixtures. Please use the 3-pin signal
output / incoming line of the lamp to connect. The
connections between the 3-pin signal line ports are
shown in the figure above. It must be noted that the 3
pin of the XLR plug / socket must not be in contact with
the inner shell or between the cores when connecting.
The XLR plug / socket and the XLR control cable cannot
be connected in any other way than the connection
shown in the figure above. This product receives the
international standard DMX512 (1990) control signal.
The signal connection of multiple fixtures, the
maximum number of connection is 32 fixtures, use
a 3-pin signal cable from the DMX output port of the
controller to the DMX input line of the 1st fixture, and
connect from the DMX output line of the first fixture
To the DMX input line of the second fixture, and so on,
until all the fixtures are connected.
When the first fixture is not connected to the
controller (the signal line connection between the
other fixtures remain unchanged), it is the connection
mode of master-slave synchronous control. However,
to achieve master-slave synchronization control, the
first fixture should be set as the master in the menu,
and the remaining fixtures should be set as slaves (the
default value is slave).
When connecting the power supply, the power supply
of each fixture should be connected separately. Please
note that the power supply voltage and frequency
mustmatch with the power supply voltage and
frequency listed in the product manual.
DMX OUT
DMX IN
DMX 512
PIN FUNCTION
1 GND
2 DATA +
3 DATA -
2
2
3
3
1
1
Press button
UP
or
DOWN
if you want to browse
through the various Setup Options.
Press button
ENTER
to save your settings or enter
next menu.
Press button
UP
or
DOWN to shift.
Press button
MENU
will return to the upper menu
one by one.
