NEO TOOLS 75-200, Instruction Manual

Page: 15 / 100

neo-tools.com
15
Measurement unit selector
Press the UNIT button to change measurement unit. Press the button
repeatedly to cycle through the units.
Cycle sequence:
m -> mm -> in -> ft.
Reference point
By default rear surface of the range finder is the reference point. You can set up
two reference points: rear or front surface of the range finder. Press the button
to change the reference. Pressing the button again will cycle through the setting.
Cycle sequence: back -> front
Distance measurement
WARNING!
Switching the tool on will activate the laser pointer. Notice the indicator for
laser pointer on/off.
Single measurement
1. After switching the device on wait a few seconds until measurement
function appears on the display.
2. Press the button to indicate measured object with the laser pointer.
3. Once the laser beam points the right spot, press the button again to
make a measurement.
4. The device will confirm the measurement and display measured value.
5. Press the power button to clear the measured value.
6. After measurement the laser light switches off automatically.