neo-tools.com
7
1.
Switch
2.
Self levelling lock switch
3.
Battery lid
4.
Stand thread
* Differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY / SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1.
Bit holder quick release
2.
Case
Battery replacement
•
Carefully pull the lid latch from the outside in order to unlock the battery lid (
3
).
•
Insert 2 new AAA batteries, observe correct polarity.
•
Close the battery lid, make sure the latch snaps in place.
USE OF MAGNETIC HOLDER
•
In order to attach the cross line laser to the magnetic holder, drive the threaded pin (
2
) into stand thread in the
laser base, use the wheel (
1
).
•
The wheel (
1
) allows to set the cross line laser to the right or left.
•
The knob (
3
) allows to set the cross line laser up or down.
•
The magnets (
4
) allow to attach the stand to metal surfaces.
•
The holder is equipped with stand threads ¼” (
5
) and 3/8” (
6
).
HOW TO OPERATE THE LASER – SELF LEVELLING FEATURE
The laser offers self-levelling feature. The feature is operational within ±5° of the laser tilt.
•
Switch the laser on, slide the self-levelling lock switch (
2
) to unlocked position.
•
When the laser angle does not allow the self levelling feature to work (greater than 5°), the laser will signal the
problem by flashing and switching on the red indicating diode next to the switch (
1
).
•
Set up the laser so it does not signal incorrect position, only then it will be possible to set vertical and horizontal
line.
•
Press the switch (
1
) to toggle between showing horizontal line, vertical line and both.
•
To switch the laser off, slide the self-levelling lock switch (
2
) to locked position.
