D E S I G N C U S T O M I Z A T I O N
1
Installation Preparation
This chapter provides information
required
for the installation
of the Neo Changer, it must be read by all users.
Thank you for purchasing the Neo Changer. Since the Neo Changer will works in
many different vehicles the following steps must be taken to ensure the changer is set
up correctly for the vehicle it is being installed in.
Before Installation
To prevent damage to your vehicle and the changer take the following precautions.
1.
Turn off the ignition and remove the negative (-) battery cable prior to
installation.
NOTE:
If the vehicle is equipped with an on-board drive or navigation computer, do
not disconnect the battery cable. If the battery cable is disconnected, the computer
memory may be lost. Under these conditions, use extra caution to avoid causing a
short circuit during installation.
If your radio has a security code make sure you
know the code and how to enter it prior to removing the battery cable. The
radio will require this code to operate when the battery terminal is reconnected.
2.
Do not install the unit in the following locations:
A.
Locations exposed to direct sunlight
B.
Locations where hot air flows from the cars heater
C.
Locations with excessive vibration
3.
When using the supplied brackets and screws be careful not to
penetrate any existing wires when tightening screws or installing the
grounding wire.
4.
The changer must be installed at a horizontal, vertical, or 45° angle.
See the following page for instructions on setting the angle.
Chapter
1
