16
FG7C CONTROLLER: Programming the FG7C
DRAWING THE ZONES AND GATES LINES
1)
On the FG7, press the PIN tab on the top screen and Select
▼
Installer. Enter the
appropriate PIN number and press Enter. Check that Installer stays on the screen and
has no revert back to Select.
2)
Press the Image tab on the top of the screen.
3)
Use the
▼
and
▲
keys under Energ# symbol to select the desired energizer.
4)
Use the
▼
and
▲
keys under Zone# symbol to select the desired zone.
5)
Press “Start” and touch the screen at the desired points corresponding to that sector.
Once the last point is reached press “Stop”. A maximum of eight points is permissible.
Press “View” to see what your sector looks like. If unhappy with the result simply press
“Start” and repeat the procedure.
Please note that a USB mouse can be used to assist with drawing the lines.
6)
A Gate can be associated with each energizer, but only has two points. Press “Gstrt” and
touch the screen at the start point and end point of the gate. Press “View” to confirm
your entry.
7)
You can randomly do all energizers, zones and gates using steps 3 to 6 above.
8)
When you are happy with the zone and gate lines press “Save”
9)
The system will automatically load this graphic layout on power-up. You may after
entering Installer mode, edit any sector independently and then re-save.
10)
The labels E1:Z1 (Energizer Address, Zone number) and E1:Z2 etc. are placed
automatically at the start of each fence sector.
SETTING THE IP ADDRESS
1)
On the FG7, press the PIN tab on the top screen and select
▼
Installer, enter the
appropriate PIN number and press enter. Check that Installer stays on the screen and
has not revert back to select.
2)
Press the System tab on the top of the screen and use the
▼
and
▲
markers next to
the address boxes to set the correct IP address, Network Mask and Gateway address.
3)
Press the Set IP Address button on the bottom of the screen and the new IP address will
be programmed into the FG7.
4)
To ensure that the setting is correct ping the new IP address from a computer.