7
FG7B CONTROLLER: Programming the FG7B
PROGRAMMING THE FG7B-DRUID
The FG7B-Druid should be programmed with the number of energizers as well as the IO cards in
the system.
If required a graphic site image can be loaded on the FG7B-Druid and zones (sectors) as well as
Gate lines can be drawn on the image.
CONFIGURE THE NUMBER OF ENERGIZERS ON THE
NETWORK
1)
On the FG7, press the PIN tab on the top screen and select
▼
Installer, enter the
appropriate PIN number and press Enter. Check that Installer stays on the screen and
has not revert back to select.
2)
Press the System tab on the top of the screen and use the
▼
and
▲
markers next to the
number of energizers to select the correct number of energizers in the network.
Press Save No of Energizers.
3)
If jumper 4 and 6 are set to auto reset (normal operation), then after about two minutes
the application will restart. Otherwise one can push the B3-PWR button and this will close
the application and after the Nemtek logo has disappeared from the screen you press the
B3-PWR button again to restart the unit.
4)
Check under the system tab that the number of energizers is now correct.
CONFIGURE THE NUMBER OF IO CARDS ON THE NETWORK
1)
On the FG7, press the PIN tab on the top screen and select
▼
Installer, enter the
appropriate PIN number and press enter. Check that Installer stays on the screen and
has not revert back to select.
2)
Press the System tab on the top of the screen and use the
▼
and
▲
markers next to the
number of IO cards to select the correct number of IO cards in the network.
Press Save No of IO cards.
3)
IF jumper 4 and 6 are set to auto reset (normal operation), then after about two minutes
the application will restart. Otherwise one can push the B3-PWR button and this will close
the application and after the Nemtek logo has disappeared from the screen you press the
B3-PWR button again to restart the unit.
4)
Check under the system tab that the number of IO cards is now correct.
Summary of Contents for FG7B
Page 19: ...19 End of document ...
