Page 7
P: 419.542.7751 ● F: 419.542.6690 ●
800.782.6761
● nemcofoodequip.com
INSTALLATION
Remove the packaging and all packing material from the sandwich press.
Check for any signs of shipping damage. If shipping damage is discovered, contact the shipping company
AS SOON AS damage is discovered.
LOCATING AND INSTALLING
Verify that you have an area on a counter top that is at least 18” wide and that is within 6’ of a 30 amp
receptacle that matches the sandwich press plug type.
Only install this appliance in a well-ventilated area. Verify that hot air from other cooking appliances can’t
be drawn into the back cooling fans of the sandwich press. *if the sandwich press must be placed adjacent
to a heat source, then a heat shield should be placed between the appliances to protect the sandwich
press.*
The appliance should be placed on a flat level surface that is suitable for the weight of the sandwich press;
adjust the legs as needed.
A minimum of 2 inches (51mm) of clearance at the sides and 2 inches (51mm) behind the unit is required
to ensure there is no interference when opening and closing the upper enclosure. Also, ensure that there
is enough room above the upper enclosure to allow it to fully open.
DO NOT apply any stickers or instructions to the outside of the appliance that interfere with or contradict
the manufacturer’s installed warning labels.
