Start-up and Operation
6. Verify that the inlet water hose in not under pressure. Release the On/Off Valve Control
Rod by turning the rod stem down. The rod should slide forward. Turn the stem back up
180 degrees and verify that the cable is not pinched or bound.
7. Verify that the sprinkler head is adjusted correctly. See “Sprinkler Adjustment”.
Caution: Never
adjust an operating sprinkler head. Pressurized water from a sprinkler can
inflict serious injury to operators and bystanders.
8. Caution: Verify that it is safe to begin irrigation. Turn on the water source to begin irrigating.
9. To adjust the speed of the irrigator, refer to page 22 of this manual.
10. The RainTrain2
®
. will shut itself off at the end of the irrigation run when the control rod
actuator is pulled against the control rod. You may also stop the irrigation by turning
off the water.
11. Once the RainTrain2
®
. has automatically stopped itself at the end of the irrigation run,
turn off the water. Verify that the water has been shut off before approaching the machine.
Caution: The hose may still be under pressure. Safely relieve the water
pressure before approaching the RainTrain2
®
The unit could
become active if the control rod is jarred to the on position.
17
Figure 11c.
Summary of Contents for RainTrain2
Page 1: ......
